Correct usage method of electronic jacquard faucet machine

The correct use of electronic jacquard faucet machine involves multiple steps and key points. The following is a clear usage guide summarized based on the information in the reference article:

1、 Preparation for startup

Check the power connection to ensure stable power supply.

Check if all control components are connected properly and there is no looseness.

Check if the mechanical components such as the transmission shaft and gearbox are securely installed and there are no abnormalities.

2、 Power on operation

Turn on the main power switch circuit breaker (located on the right side of the chassis).

Select and press the motor start (green) button as needed to start running the machine.

3、 Basic operations

Jog operation: Press the jog button, the machine will perform jog operation, with a minimum movement of 2-3 mm each time. The jog button also has a positioning parking function, and the loom stops in the flat brown position (crankshaft 295 °).

Start operation: Press the start button, the machine will start quickly, and the four color indicator lights will reset.

Emergency stop operation: Press the emergency stop button at any position, and the machine will immediately stop running.

One weft operation: Press the one weft button, and the loom will stop at the open position (crankshaft 115 °). After starting, the one weft button also has a positioning parking function, and the loom stops at the flat brown position (crankshaft 295 °).

4、 Fault handling

Observe the four color fault signal light and determine the type of fault based on the color of the indicator light:

Orange: Automatic parking indicator for weft storage failure.

Green: Automatic stop indication for broken weft.

Red: Automatic stop indication when disconnected.

White: Automatic parking indication for protection.

Take corresponding measures according to the type of fault, such as replacing yarn, checking sensors, adjusting machine parameters, etc.

5、 Precautions

During the operation, it is strictly prohibited to cross the guardrail. Be careful when going up and down stairs to prevent slipping.

It is strictly prohibited to detach the cross bars of the corrugated board crossing the bridge, hang them on the ground of the gantry without permission, and roll them off to avoid injury to equipment and vehicle blocking workers.

Do not place tools randomly to prevent accidents caused by falling or falling during operation.

When the safety barrier is moved due to maintenance needs, it should be promptly restored and returned to its original position after the maintenance is completed.

After maintenance, the machine should be turned on and run slowly for at least 2 seconds. Only after confirming normal operation can fast running be carried out to ensure the quality of the fabric and the normal operation of the equipment.

6、 Other functional operations

Flexibly adjust the jog sensitivity to meet different weaving needs.

Flexibly adjust the positioning parking angle to ensure that the machine's driving and parking are in the optimal position.

The above is the correct usage method of the electronic jacquard faucet machine. Please strictly follow the operating steps when using it to ensure the normal operation of the machine and the quality of weaving.